Locate and Clean the Lint Filter in your Samsung Dryer

Last Update date : 2024-07-21

To guarantee smooth performance, it's critical to routinely clean the lint filter on your Samsung dryer. The NC/NC1 code* on your dryer's display or the lint filter warning may both serve as reminders for you to change the filter. In any scenario, kindly inspect and clean your dryer's lint filter.

Locate and Clean the Lint Filter in your Samsung Dryer Locate and Clean the Lint Filter in your Samsung Dryer

To find and clean the lint filter on your specific model, refer to the instructions below:

1 Open the door and pull the lint filter upward to remove.
lint filter
2 Open the outer filter and remove the inner filter.
inner filter
3 Unfold both the inner filter and outer filter.
4 Remove the lint from both filters, and then clean the filters with a cleaning brush.

• To clean the filters thoroughly, clean the filters in running water and then dry them completely.

• Do not dry the filter under direct sunlight; this can damage the filter.

• Make sure to dry the filter in the shade completely before reassembling.

 inner filter and outer filter.
5 Put the inner filter into the outer filter, and then reinsert the lint filter into the original position.
inner filter

Note: 

  • Clean the lint filter after each load. Otherwise, the drying performance may decrease.
  • Do not operate the dryer without the inner filter inside the outer filter.
  • Using the dryer with a wet lint filter may cause mould, bad odours, or a decrease in drying performance.
  • For a guide on cleaning the heat exchanger, please click here.
  • If the NC/NC1 code persists after checking and cleaning, please contact us

Thank you for your feedback!